Avaya BCM Management Guia do Utilizador descarregar pdf (Página 90)

86 Chapter 2 Fault Management System

P0609330 2.0

8 Click the Save button.

Manager IP

Address

Allows you to specify the IP addresses of the SNMP trap subscriber stations. If you have too

many IP addresses in the trap community list, the SNMP service may degrade system

performance.

The IP address must correspond to the PC where the trap collector software is installed.

Do not use the dynamic IP address that the PC receives when the dial-up link activates (as the

BCM initiates dialing). Using the dynamic IP address causes the removal of the required static

route.

Interface Allows you to specify the method to route SNMP traps to the SNMP trap collector.

If the trap collector is on the same subnet as one of the BCM LAN or WAN interfaces, select

'RouterAssigned' as the Interface value. The RRAS decides how to route the packet to the trap

collector according to its current routing table.

If you want to let the BCM send trap packets to the trap collector via the dialup interface, select a

demand dial interface as 'Interface'. The BCM automatically adds (under IP routing) a static route

for the trap collector that points to the dial-out V.90 modem or ISDN interface. Configure a trap

community entry with the trap collector IP address as the trap destination. Select

'RouterAssigned' or one of the dial-out interfaces listed in the drop-down list.

The types of communication links are as follows:

• Select RouterAssigned: The route for the trap destination is automatically determined and

handled by the RRAS. Enter the IP address of the trap collector in the Manager IP Address

field.

• V.90 Dial-out: The interface is specified through Resources/dialup/V.90/Modemtrapdialout.

The BCM will automatically dial-out to the SNMP trap collector telephone number. Specify the

dial-out information under the V.90 Link Parameters tab. The Modembackup is not used for

the auto SNMP trap dial-out feature.

• ISDN BRI (Europe/North America): The interface is specified through Resources/dialup/

ISDN. The BCM will automatically dial-out to the SNMP trap collector phone number.

• ISDN PRI (Europe): The interface is specified through Resources/dialup/ISDN. The BCM will

automatically dial-out to the SNMP trap collector phone number.

Table 11 SNMP Trap List attributes (Continued)

Attribute Description

1 2 ... 85 86 87 88 89 90 91 92 93 94 95 ... 487 488

Sem comentários

Avaya BCM Management Guia do Utilizador Página 90