Avaya BCM Management Guia do Utilizador descarregar pdf (Página 37)

Chapter 1 Management Overview 33

Business Communications Manager - Management User Guide

Network administration personnel have the ability to configure, observe and control the operation

and performance of the Business Communications Manager through one of the available access

portals. The following interfaces provide management access to the Business Communications

Manager (see Figure 4):

• WAN IP interface: WAN internet access (IP access through the Unified Manager interface)

The WAN interfaces use T1 (with CSU), V.35, X.21, PRI/BRI MBMs Dial on demand.

Establish a connectivity path provided from the corporate LAN network to the end-user’s

WAN network or ISP over another WAN device (e.g. router elsewhere on the enterprise

premises).

• V.90 Dial-up modem interface: (North America option only) The dial-up connection

interface is available for occasional use. Due to modest dialup speeds, and potentially large file

sizes, dial-up has limited use. For regular backup/restore and configuration tasks, use a higher

bandwidth connection for management access to the Business Communications Manager.

• Local RS232 serial interface (COM port): Local terminal emulation interface. The Business

Communications Manager platform base chassis has a serial RS232 port. The RS232 port

provides local terminal emulation connectivity to the BCM. This method is normally used

upon initial install. Use local connectivity to set the system’s IP address and other basic system

and networking parameters to enable the BCM for remote access. Alternatively, the RS232

port is used to establish a local connection to perform local maintenance activities in the event

of an IP network communications failure.

• LAN IP interface: local LAN port (IP access through the Unified Manager interface). The

LAN Ethernet interface transmits at 10/100 Mbps. Use IP over a LAN Ethernet interface.

Figure 4 Business Communications Manager physical interfaces

WAN card (field upgrade) connects the Business Communications Manager system to the wide area network.1

V.90 Modem port (available in North America only) provides PSTN dial-up access to the BCM.

Local RS232 COM port provides a serial connection to a laptop for maintenance purposes. Also supports a

DB9 serial connection to a UPS for power monitoring (see

UPS Installation and Configuration Guide

Ethernet port connector #2 provides access to internal local area network

Ethernet port connector #1 provides access to external local area network

CTM 4

1Aux 2 3 4

DSM 16+

1234 1234

StatusPower

CTM

DSM

DECT

Unpopulated

21 3 4 5

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 487 488

Sem comentários

Avaya BCM Management Guia do Utilizador Página 37