
Configuring WAN Line Services
B-14
308648-14.00 Rev 00
Total Time Up/Down If the line is not up (Operational State does not equal Up),
then three dashes (---) appear. If the line is up (Operational
State equals Up), then the value appears in the form:
hh
h
mm
m
ss
s
where
hh
is hours,
mm
is minutes, and
ss
is seconds. For
example, the value might appear as
5h31m05s
. If the value is
greater than 24 hours, it appears in the form:
dd
d
hh
h
mm
m
where
dd
is days,
hh
is hours, and
mm
is minutes. For
example, the value might appear as
2d10h15m
.
MAC Address Media access control address: the physical address of the
line. The line driver fills in this address from the 48-bit address
stored in the link module number PROM for this connector.
MTU Maximum transfer unit size -- the buffer size for the FT1 or
FE1 port (also the largest frame that can be transmitted or
received across the FT1 or FE1 port). The value ranges from
3 to 4608 bytes.
WAN Protocol WAN protocol enabled on this interface.
Local Address The 1-byte local HDLC address of this interface.
Remote Address The 1-byte remote HDLC address of this interface.
BOFL Enables the transmission of proprietary BofL messages over a
point-to-point connection between the local router and a
remote peer.
BOFL TMO BofL Timeout -- the time between transmissions of BofL
messages from this interface.
Receive Bytes Number of octets received without error.
Receive Frames Number of frames received without error.
Receive Average Packet Average number of packets received without error.
Transmit Bytes Number of octets transmitted without error.
Transmit Frames Number of frames transmitted without error.
Transmit Average Packet Average number of packets transmitted without error.
Total Errors/Receive Total number of errors received.
Total Errors/Transmit Total number of errors transmitted.
(continued)
Comentários a estes Manuais