Avaya Configuring WAN Lines Services Manual do Utilizador descarregar pdf (Página 192)

100

101

Configuring WAN Line Services

7-58

308648-14.00 Rev 00

To set the port test parameters, complete the following tasks.

Enabling or Disabling BERT Mode

Enable BERT mode for BERT testing using Site Manager.

By setting this parameter, you enable or disable BERT mode on all logical lines

except QMCT1 and DMCT1 net module interfaces. On these interfaces, you can

enable or disable BERT mode on individual logical lines.

See the BERT Mode parameter on page A-41 for information.

Setting the BERT Alarm Type

Using Site Manager, you can specify the type of alarm signal to be generated

while in BERT mode, or disable the generation of alarm signals altogether.

See the BERT Alarm Type parameter on page A-41 for information.

Site Manager Procedure

You do this System responds

1. In dynamic mode, click on a configured

MCT1 or MCE1 connector in the

Configuration Manager window.

The Logical Lines window opens.

2. Click on

Port Details.

The Port Parameters window opens.

3. Click on

Line Tests.

Note that the Line

Tests option appears only in dynamic

mode

The Port Actions window opens.

4. Edit the port action parameters, located in

the upper portion of the window.

5. After setting a parameter, click on

Apply

6. Click on

Done

when you are finished

setting port action parameters.

Note:

All changes you apply to the port in the Port Actions window are in

effect only while the window is active. When you exit the Port Actions

window, all port settings revert to the original settings.

1 2 ... 187 188 189 190 191 192 193 194 195 196 197 ... 461 462

Comentários a estes Manuais

Sem comentários

Avaya Configuring WAN Lines Services Manual do Utilizador Página 192

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Avaya Configuring WAN Lines Services