Avaya Configuring WAN Lines Services Manual do Utilizador descarregar pdf (Página 222)

100

101

Configuring WAN Line Services

8-20

308648-14.00 Rev 00

Setting Relay Control

The relay on the link module automatically goes into loopback mode when a

system power up, reboot, or crash, or a hardware reset occurs. You can control the

state of the relay by setting the Relay Control parameter.

In the BCC, the options for Relay Control are:

• loop -- The default; the relay will go into loopback as the port/module is

reinitialized

• noloop -- The relay will remain in its present state as the port/module is

reinitialized

To set relay control using the BCC, navigate to the ft1 prompt (for example,

box

;

ft1/1/1

) and type:

relay-control

variable

For example:

ft1/1/1#

relay-control noloop

Configuring a Non-PRI Logical Line

Logical lines are the logical paths for data communication on a physical

connection. You can define only one logical line for FT1 ports. For instructions on

how to define logical lines, see the sections that follow.

Defining Logical Lines Using the BCC

A single FT1 port supports up to 24 logical lines.

Adding a Logical Line to an FT1 Port

To add a logical line to an FT1 port, navigate to the ft1 prompt (for example,

box

;

ft1/1/1

) and type:

ft1/1/1#

logical-line

Note:

If you want to group the logical lines into a multiline circuit, see

Chapter 9, “Configuring Multiline Services.”

1 2 ... 217 218 219 220 221 222 223 224 225 226 227 ... 461 462

Comentários a estes Manuais

Sem comentários

Avaya Configuring WAN Lines Services Manual do Utilizador Página 222

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Avaya Configuring WAN Lines Services