
Configuring WAN Line Services
7-4
308648-14.00 Rev 00
Using Site Manager
To select the port application, complete the following tasks.
Select NONPRI to indicate that all of the lines have a permanent circuit number
and are for leased lines, frame relay, or permanent connections for other
non-ISDN PRI applications.
Select PRI to indicate that the lines are for switched circuits using ISDN.
Continue with the next section, “Setting the Clock Parameters.”
Site Manager Procedure
You do this System responds
1. In the Configuration Manager window,
click on an unconfigured MCE1 or MCT1
connector.
The Port Application window opens.
2. Set the Port Application Mode parameter
to
NONPRI
or
PRI
.
Click on
Help
or see the parameter
description on page A-24 for MCE1
networks, or page A-28 for MCT1
networks.
3. Click on
OK
. The Edit Clock Parameters window
opens.
Note:
The 120-ohm MCE1 II link module supports ISDN PRI. MCE1 net
modules support only non-PRI applications. If you try to configure an ASN
MCE1 port for PRI, Site Manager displays a warning to indicate that this
version of MCE1 does not support ISDN.
Comentários a estes Manuais