
Configuring IP Services
2-12 114065 Rev. A
Starting EGP
Before you can select a protocol to run on the router, you must configure a circuit
that the protocol can use as interface to an attached network. For information and
instructions, see Configuring Line Services.
The Select Protocols window opens.
1. Select IP and EGP from the Select Protocols window and click on OK.
Site Manager displays the IP configuration window.
2. Edit the IP Configuration window as described in
“Starting IP” on page 2-3.
3. Click on OK.
The EGP Neighbors Parameters window opens.
4. Supply the following information:
• IP address of the remote neighbor. There is no default for this parameter.
Use Site Manager to supply the address.
• Gateway mode of the remote neighbor. There is no default for this
parameter. Use Site Manager to specify the mode: core or noncore.
5. Click on OK.
Deleting EGP from the Router
You can delete EGP from all router circuits on which it is currently enabled. To
delete EGP, begin at the Configuration Manager window and complete the
following steps.
1. Select Protocols > IP > BGP > Delete EGP.
A window opens, prompting, “Do you really want to delete EGP?”
2. Click on OK.
Site Manager: Remote Autonomous System IP Address parameter: page A-19
Site Manager: Gateway Mode parameter: page A-19
Comentários a estes Manuais