
Site Manager Parameters
114065 Rev. A A-9
Parameter: Connect Retry Timer
Path: Configuration Manager > Protocols > IP > BGP > Peers
Default: 120 seconds
Options: 0 to 2147483647
Function: Specifies the maximum number of seconds allowed between TCP connection
attempts for this peer connection.
Instructions: Either accept the current value or set this parameter to some other value. A
value of 0 indicates that no active attempt to establish a BGP connection to the
peer is to be done. Incoming calls from the peers will be accepted.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.5.1.2.1.12
Parameter: Holdtime
Path: Configuration Manager > Protocols > IP > BGP > Peers
Default: 90 seconds
Options: 0 or any decimal number greater than 2
Function: Specifies the holdtime that will be inserted into an Open message. Upon receipt
of the peer’s Open message, the lesser of the two holdtimes will be used (this
must be at least 3 seconds). There are two exceptions. If one peer sends a zero
holdtime, then the non-zero holdtime is used. If both peers send zero holdtimes,
then no holdtime is used. The calculated holdtime is the amount of time either
peer will wait for a Keepalive or Update message before declaring the
connection down.
Instructions: Either accept the current Holdtime Timer value or set the parameter to 0 or
some value greater than 2 seconds.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.5.1.2.1.13
Comentários a estes Manuais