
Customizing IP Services
114065 Rev. A 3-45
Defining a Static Route
A static route is a manually configured route that specifies the transmission path a
datagram must follow, based on the datagram’s destination address. A static route
specifies a transmission path to another network. You configure a static route if
you want to restrict the paths that datagrams follow to paths you specifically
configure.
Static routes remain in IP routing tables until you remove them. Note, however,
that if the interface that was used to reach the next hop in the static route becomes
disabled, the static route disappears from the IP routing table.
You can use Site Manager to
• Specify the state (active or inactive) of the static route record in the IP routing
tables.
• Specify the IP address of the network to which you want to configure the
static route.
• Specify the subnet mask of the destination network.
• Specify the number of router hops a datagram can traverse before reaching the
destination IP address. The IP router uses the cost value when determining the
best route for a datagram to follow.
• Specify the IP address of the next-hop router.
• Specify the subnet mask of the next-hop router.
• Specify a weighted value (from 1 to 16, with 16 being the most preferred) that
the IP router uses to select a route when its routing tables contain multiple
routes to the same destination.
• Specify the local router circuit associated with the static route over an
unnumbered interface.
Site Manager: Enable parameter: page A-47
Site Manager: Destination IP Address parameter: page A-48
Site Manager: Address Mask parameter: page A-48
Site Manager: Cost parameter: page A-49
Site Manager: Next Hop Addr parameter: page A-49
Site Manager: Next Hop Mask parameter: page A-49
Site Manager: Preference parameter: page A-50
Site Manager: Unnumbered CCT Name parameter: page A-50
Comentários a estes Manuais