
Customizing IP Services
114065 Rev. A 3-49
zzzzzpdddbbb
where:
All BFE hosts are members of Class A IP networks. The format of a BFE IP
address is as follows:
nnnnnnnn.Zpppdddd.ddddddbb.bbbbbbbb
where:
BFE supports only physical addressing. It does not support either logical
addresses or subaddresses.
Configuring Blacker Front End Support
To configure BFE support on an IP interface, you must
• Configure an X.25 interface that conforms to the BFE requirements described
in this section.
• Enable the IP routing protocol on the interface.
• Enable RIPSO support on the interface.
Beginning at the Configuration Manager window, perform the following
procedures:
zzzzz
is zero
p
is the BCD encoding of the port ID
add
is the BCD encoding of the domain ID
bbb
is the BCD encoding of the BFE ID
nnnnnnnn
identifies the network ID in bits
Z
is zero
ppp
is the port ID in bits
dddd.dddddd
is the domain ID in bits
bb.bbbbbbbb
is the BFE ID in bits
Comentários a estes Manuais