Avaya Configuring IP Services Manual do Utilizador Página 114

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 415
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 113
Configuring IP Services
3-50 114065 Rev. A
1. Configure an X.25 interface.
When you initially configure packet-level parameters for the X.25 interface,
make certain to
a. Set the Network Address Type parameter to BFE_NETWORK.
b. Set the DDN IP Address parameter to the IP address that is assigned to
your BFE connection.
2. Edit the packet-layer parameters for the X.25 interface so that they
match the settings specified in
Table 3-3.
3. Add network service record(s) to the X.25 interface.
4. Edit the network service record parameters for the X.25 interface so that
they match the settings specified in
Table 3-4.
Remember to set the DDN BFE parameter to Enable.
5. Enable the IP routing protocol on the X.25 interface.
The IP address specified must match the one specified in the packet-layer
parameter setting.
6. Edit the IP interface record.
The address resolution must be set to X.25 BFE DDN. Also configure IP
security options (RIPSO) on the interface. IP security must be enabled and
labels are required on all outbound data.
For instructions on performing Steps 1 through 4, see Configuring X.25 Services.
For instructions on performing Steps 5 and 6, see the section “Configuring the
Revised IP Security Option on an Interface” on page 3-37.
Note: Generally, the synchronous line parameter settings are the same for both
a DDN X.25 link and a BFE X.25 link. However, if your operating
environment has specific needs, you may want to edit synchronous line
parameters. See the appropriate protocol manual for instructions.
Vista de página 113
1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 414 415

Comentários a estes Manuais

Sem comentários