
Starting IP Services
114065 Rev. A 2-3
Starting IP
Before you can select a protocol to run on the router, you must configure a circuit
that the protocol can use as an interface to an attached network. For information
and instructions, see Configuring Line Services.
When you have successfully configured the circuit, the Select Protocols
window opens.
1. Select IP from the Select Protocols window and click on OK.
The IP Configuration window opens.
2. Supply the following information:
• An IP address for this interface. There is no default for the IP address.
You must supply an address or enter 0.0.0.0 to indicate that this is an
unnumbered interface. (For information about unnumbered interfaces, see
“Configuring an Unnumbered IP Interface” on page 2-16.)
• A subnet mask. When you specify an address, IP automatically calculates
an appropriate subnet mask, depending on the class of network. You can
use Site Manager to override the default mask.
• A transmit broadcast address. By default, IP uses a broadcast address that
consists of all 1s. You can use Site Manager to override the default.
• An associated IP address. If you are configuring an unnumbered IP
interface, use Site Manager to supply an associated IP address.(For
information about unnumbered interfaces, see “Configuring an
Unnumbered IP Interface” on page 2-16.)
Site Manager: IP Address parameter: page A-22
Site Manager: Subnet Mask parameter: page A-22
Site Manager: Transmit Bcast Addr parameter: page A-23
Site Manager: UnNumbered Assoc Address parameter: page A-23
Comentários a estes Manuais