
Configuring IP Services
A-36 114065 Rev. A
Parameter: Enable Security
Path: Configuration Manager > Protocols > IP > Interfaces
Default: Disable
Options: Enable
| Disable
Function: Specifies whether Revised IP Security Option (RIPSO) is enabled for the
interface.
Instructions: If you do not support RIPSO on your network, simply accept the default
setting, Disable. If you are configuring RISPO support, set this parameter to
Enable. Then see “Configuring RIPSO Support” for instructions on setting the
rest of the RIPSO parameters that you must configure. Once you set this
parameter to Enable, you can access the rest of the RIPSO parameters. If you
do not enable this parameter, Site Manager does not activate the RIPSO
parameters.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.4.1.76
Parameter: UnNumbered Assoc Alternate
Path: Configuration Manager > Protocols > IP > Interfaces
Default: Disable
Options: Enable
| Disable
Function: Automatically assigns an alternate associated address to an unnumbered
interface in the event that the primary associated address has gone down. IP
uses the first available interface.
Instructions: Use the alternate unnumbered address option to ensure that the unnumbered
interface has a usable associated address on the router.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.4.1.111
Comentários a estes Manuais