
Site Manager Parameters
114065 Rev. A A-45
Parameter: RIP Maximum Equal Cost Paths
Path: Configuration Manager > Protocols > IP > Global
Default: 1
Options: 1 to 5
Function: Specifies the maximum number of equal-cost paths allowed for a network
installed in the routing table by RIP.
Instructions: Use the IP global Multipath Method parameter to enable multipath costs and
specify the method that IP uses to choose the next hop for a datagram.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.1.17
Parameter: Multiple Next Hop Calculation Method
Path: Configuration Manager > Protocols > IP > Global
Default: Disable
Options: Enable
| Disable
Function: Enables and disables equal-cost multipath support for RIP and OSPF and
specifies the method that IP uses to choose the next hop when more than one is
available. Three methods are available: round-robin selection, selection based
on the source addresses (IP forwards all packets with the same source address to
the same next hop), and selection based on the source and destination address
(IP forwards all packets with the same source and destination address to the
same next hop).
Instructions: Configure RIP and OSPF to support equal-cost routes to the same destination.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.1.18
Parameter: ISP Mode
Path: Configuration Manager > Protocols > IP > Global
Default: Disable
Options: Enable
| Disable
Function: Enables and disables internet service provider (ISP) features.
Instructions: Use this parameter to configure BGP as a soloist and to disable the use of
forwarding tables on IP interfaces.
MIB Object ID: 1.3.6.1.4.1.18.3.5.3.2.1.1.19
Comentários a estes Manuais