Avaya Configuring Line Services Manual do Utilizador descarregar pdf (Página 236)

Configuring Line Services

8-6

If this is a multiline circuit, conﬁgure multiline resource reservation

parameters.

To conﬁgure resource reservation on multiline circuits, edit the Multiline

Select Algorithm and Multiline Threshold Bandwidth parameters. See the

parameter descriptions following this procedure for information.

7. Modify or verify the default queuing of trafﬁc for reserved and

unreserved bandwidth.

To conﬁgure default queuing of reserved trafﬁc, edit the Trafﬁc Queuing

Algorithm, Policing Algorithm, Bandwidth Interval, and Inﬂate Reservations

Percentage parameters. To conﬁgure default queuing of unreserved trafﬁc,

edit the Unreserved Policing Algorithm and Unreserved Queue Length

parameters. See the parameter descriptions following this procedure for

information.

8. Modify or verify the maximum latency for a reserved-ﬂow packet.

Edit the Reservation Latency parameter. See the parameter descriptions

following this procedure for information.

9. Click on OK.

Parameter: Estimated Bandwidth

Default: 0

Range: 0 to 214748364 bits/s

Function: Speciﬁes the estimated usable bandwidth for this line.

Instructions: Enter the estimated total bandwidth for this line in bits/s. To enable line

resource management, enter a value greater than zero. For point-to-point

lines, you can usually enter the total line speed.

For an Ethernet line, you must estimate a value, because shared-media

lines may not have all of the bandwidth available. You can base the

estimate on line statistics, the number of connected workstations, or other

site-speciﬁc information.

MIB Object ID: 1.3.6.1.4.1.18.3.5.16.2.1.3.1.3

1 2 ... 231 232 233 234 235 236 237 238 239 240 241 ... 267 268

Sem comentários

Avaya Configuring Line Services Manual do Utilizador Página 236