Avaya Configuring Line Services Manual do Utilizador descarregar pdf (Página 158)

Configuring Line Services

5-24

Parameter: Remote HDLC Address

Default: 7

Range: 1 to 255

Function: Speciﬁes the 1-byte HDLC address of the remote MCE1 interface, as

follows:

Instructions: Select an appropriate remote HDLC address. Site Manager assumes that

the values you enter are decimal. To enter a hexadecimal value, preface

the value with 0x; for example, 0x10.

Use unique HDLC addresses for the local and remote interfaces at either

end of the point-to-point circuit. If you conﬁgure a device at one end of a

point-to-point connection with a local address of DCE and a remote

address of DTE, you must conﬁgure the device at the other end with a

local address of DTE and a remote address of DCE.

If you conﬁgure X.25 on this line, set this parameter to either 1 (DCE) or

3 (DTE).

When you send packets to this interface, use this HDLC address.

MIB Object ID: 1.3.6.1.4.1.18.3.4.9.6.1.17

Parameter: Rate Adaptation

Default: 64 K LSB

Options: 64 K

| 56 K MSB | 56 K LSB

Function: Determines the number of bits and their bit positions within the timeslot.

The 64 K selection uses all 8 bits in the timeslot. The two 56 K selections

use 7 of the 8 bits in the timeslot. The 56 K MSB selection does not use

the most signiﬁcant bit, and the 56 K LSB selection does not use the least

signiﬁcant bit in the timeslot.

Instructions: Select the line rate adaptation.

MIB Object ID: 1.3.6.1.4.1.18.3.4.9.6.1.18

1 Address of the DCE

3 Address of the DTE

Any other value An explicit address value

1 2 ... 153 154 155 156 157 158 159 160 161 162 163 ... 267 268

Sem comentários

Avaya Configuring Line Services Manual do Utilizador Página 158