Avaya Configuring Line Services Manual do Utilizador descarregar pdf (Página 196)

Configuring Line Services

6-26

Parameter: Service

Default: LLC1

Options: Transparent

| LLC1

Function: Sets the HDLC service type for this line. Transparent is basic HDLC

mode. LLC1 adds the HDLC address and control ﬁelds as a preﬁx to the

frame.

Instructions: Select the logical line HDLC service.

MIB Object ID: 1.3.6.1.4.1.18.3.4.9.6.1.15

Parameter: Local HDLC Address

Default: 7

Range: 1 to 255

Function: Speciﬁes the 1-byte HDLC address of this MCT1 interface, as follows.

Instructions: Select an appropriate local HDLC address. Site Manager assumes that the

values you enter are decimal. To enter a hexadecimal value, preface the

value with 0x; for example, 0x10.

Use unique HDLC addresses for the local and remote interfaces at either

end of the point-to-point circuit. If you conﬁgure a device at one end of a

point-to-point connection with a local address of DCE and a remote

address of DTE, you must conﬁgure the device at the other end with a

local address of DTE and a remote address of DCE.

If you conﬁgure X.25 on this line, set this parameter to either 1 (DCE) or

3 (DTE).

When you send packets to this interface, use this HDLC address.

MIB Object ID: 1.3.6.1.4.1.18.3.4.9.6.1.16

1 Address of the DCE

3 Address of the DTE

Any other value An explicit address value

1 2 ... 191 192 193 194 195 196 197 198 199 200 201 ... 267 268

Sem comentários

Avaya Configuring Line Services Manual do Utilizador Página 196