Avaya Configuring Line Services Manual do Utilizador descarregar pdf (Página 183)

Configuring MCT1

6-13

Parameter: Remote FDL HDLC Address Mode

Default: BY

Options: AZ

| BY

Function: Selects the FDL address mode to determine whether the near-end FDL

responds to HDLC address BY or AZ in messages from the far-end FDL.

Instructions: Specify the address mode.

MIB Object ID: 1.3.6.1.4.1.18.3.4.9.3.1.9

Parameter: Accept Loopback Request

Default: Enable

Options: Enable

| Disable

Function: Enables or disables loop-up and loop-down code detection circuitry in the

link module. When this parameter is enabled, this interface accepts and

complies with requests to go into loopback mode from a far-end device.

Instructions: Enable or disable local loopback.

MIB Object ID: 1.3.6.1.4.1.18.3.4.9.3.1.10

Parameter: Loopback Conﬁguration

Default: No Loopback

Options: No Loopback

| Payload Loopback | Line Loopback

Function: Setting this parameter forces the DS1 interface into loopback. The far-end

or intermediate equipment then performs diagnostics on the network

between that equipment and the DS1 interface. After testing, set this

parameter to No Loopback to return the interface to normal operation.

Instructions: Select the loopback conﬁguration option.

MIB Object ID: 1.3.6.1.4.1.18.3.4.9.4.1.10

Payload Loopback The received signal at this interface is looped through the

device. Typically the received signal is looped back for

retransmission after it has passed through the device’s

framing function.

Line Loopback The received signal does not go through the framing

device (minimum penetration) but is looped back out.

1 2 ... 178 179 180 181 182 183 184 185 186 187 188 ... 267 268

Sem comentários

Avaya Configuring Line Services Manual do Utilizador Página 183