Avaya Configuring Line Services Manual do Utilizador descarregar pdf (Página 170)

Configuring Line Services

5-36

Running the Tests

When you have set the test parameters, you can test the line.

To test the MCE1 line:

1. Start at the MCE1 Port Actions window (refer to Figure 5-21).

2. Click on the appropriate Send Command.

Refer to T

able 5-1 for a list of the commands and their functions.

3. Click on Apply.

4. Repeat Steps 2 and 3 for each test you want to run.

5. Click on Done.

The MCE1 Port Parameters window appears (r

efer to Figure 5-20). All

changes you apply to the port in the MCE1 Port Actions window are effective

only while the window is active. When you exit the MCE1 Port Actions

window, all port settings revert to the original port settings.

Caution: Wait until the MCE1 Port Actions window updates before selecting

another action.

Table 5-1. Send Commands for BERT Mode

Send Command Function

Reset BERT Counters Resets all counters to 0

Insert 1 Error Inserts a single (non-repeating) error

into the bit stream

Insert 1 Error/1K Inserts a deliberate error into every

thousandth position in the bit stream

Insert 1 Error/1M Inserts a deliberate error into every

millionth position in the bit stream

Disable Insert Error Stops the insertion of deliberate

errors into the bit stream

1 2 ... 165 166 167 168 169 170 171 172 173 174 175 ... 267 268

Sem comentários

Avaya Configuring Line Services Manual do Utilizador Página 170