Avaya Configuring DLSw Services Manual do Utilizador descarregar pdf (Página 123)

Customizing DLSw Services

304233-A Rev. 00

4-31

Configuring the DLSw/APPN Boundary Function

Instructions for configuring the DLSw/APPN boundary function are covered

under the following topics:

Step 1: Configuring DLSw and APPN

Before you can configure the DLSw boundary function, DLSw and APPN must

be running on the same slot on the router. Using Site Manager:

Configure DLSw on a slot.

For instructions, see Chapter 3, “Starting DLSw.”

Configure APPN on the same slot as DLSw.

You must supply information for the following APPN advanced global

parameters:

• Default DLUS Name

• Default Backup DLUS Name

Set the Max Send BTU Size and Max Receive BTU Size APPN advanced port

parameters. Set these parameters according to the size supported by the end

device. If you enable high performance routing (HPR) support, set these

parameters to 768 or greater.

The DLSw/APPN boundary function requires a setting of Enable for the

Implicit DLUR parameter. When you configure the DLSw/APPN boundary

function, Site Manager automatically sets the Implicit DLUR parameter to

Enable. Make sure that this parameter is properly set.

For information on configuring APPN, see Configuring APPN Services.

Topic Page

Step 1: Configuring DLSw and APPN

4-31

Step 2: Creating a Virtual Circuit and Adding a DLSw Interface 4-32

Step 3: Obtaining the Virtual Circuit Number 4-33

Step 4: Adding an APPN Interface to an Existing Virtual Circuit 4-34

Disabling and Reenabling the Boundary Function 4-34

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 271 272

Sem comentários

Avaya Configuring DLSw Services Manual do Utilizador Página 123