Avaya Configuring PPP Services Manual do Utilizador descarregar pdf (Página 83)

Customizing PPP

308639-14.00 Rev 00

3-29

Specifying PAP Parameters for the Remote Peer

If the remote peer does not have PAP enabled, ignore the remote PAP parameters

that follow.

During the authentication phase of link creation, PPP uses the remote PAP ID and

remote password to verify the local peer’s right to communicate with the remote

router. During the authentication phase, this interface must include the correct

remote PAP ID and remote PAP password in all password authenticate-request

messages it sends to the local peer router; otherwise, the peer router sends an

authenticate-NAK message and the link is not created.

If the remote peer has PAP enabled, specify the Remote PAP ID parameter, which

assigns a PAP identifier to the remote peer. There is no default value.

The Remote PAP Password parameter specifies the password assigned to the

remote peer router. The password can consist of any text string, up to 25

characters long. There is no default value.

Using the BCC

The BCC does not allow you to configure these parameters.

Using Site Manager

To set a PAP identifier and PAP password for the remote peer of this interface, do

the tasks in the following table.

Site Manager Procedure

You do this System responds

1. From the Protocols menu, choose

PPP

. The Interfaces menu appears.

2. Choose

Interfaces.

The Interfaces window opens.

3. Choose

Lines

. The Lines window opens.

4. Set

Remote PAP ID

. (See page A-20.)

5. Set

Remote PAP Password

(See page A-20.)

6. If you have no other PPP line parameters

to configure, click on

. Otherwise,

continue with the Lines configuration.

The Interfaces window opens.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 151 152

Comentários a estes Manuais

Sem comentários

Avaya Configuring PPP Services Manual do Utilizador Página 83

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Avaya Configuring PPP Services