Avaya Configuring PPP Services Manual do Utilizador descarregar pdf (Página 82)

Configuring PPP Services

3-28

308639-14.00 Rev 00

Specifying Local PAP Parameters

If you did not enable PAP on the local peer, ignore the local PAP parameters that

follow. If you set the local authentication protocol to PAPAUTH, specify a unique

local PAP identifier and local PAP password for this interface.

During the interface’s authentication phase, all password authenticate-request

messages the peer router sends to this interface must include the correct PAP ID

and PAP password. Otherwise, the interface sends an authenticate-NAK message

and the link is not created.

The Local PAP ID parameter specifies the identifier assigned to this interface. The

identifier can consist of any text string, up to 25 characters long. There is no

default value.

The Local PAP Password parameter specifies the password assigned to this

interface. The password can consist of any text string, up to 25 characters long.

There is no default value.

Using the BCC

The BCC does not allow you to configure these parameters.

Using Site Manager

To set a local PAP identifier and local PAP password for this interface, do the tasks

in the following table.

Site Manager Procedure

You do this System responds

1. From the Protocols menu, choose

PPP

. The Interfaces menu appears.

2. Choose

Interfaces.

The Interfaces window opens.

3. Choose

Lines

. The Lines window opens.

4. Set

Local PAP ID

. (See page A-19.)

5. Set

Local PAP Password

(See page A-19.)

6. If you have no other PPP line parameters

to configure, click on

. Otherwise,

continue with the Lines configuration.

The Interfaces window opens.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 151 152

Comentários a estes Manuais

Sem comentários

Avaya Configuring PPP Services Manual do Utilizador Página 82

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Avaya Configuring PPP Services