Avaya Configuring PPP Services Manual do Utilizador descarregar pdf (Página 65)

Customizing PPP

308639-14.00 Rev 00

3-11

This parameter enables or disables the network control protocol for IPv6. It does

not enable or disable IPv6 routing services for the interface. However, disabling

the network control protocol for IPv6 stops IPv6 traffic from being routed over

this interface.

Specifying the Type of Connection - PPP Mode

The PPP Mode parameter indicates the type of connection on this interface:

single-line, multiline, multilink, or multilink monitor. Your choice of options

depends on the type of circuit you are configuring. This section deals with how

you use Site Manager to configure each of these PPP modes.

Table 3-1

compares the various PPP modes.

Site Manager Procedure

You do this System responds

1. From the Protocols menu, choose

PPP

. The Interfaces menu appears.

2. Choose

Interfaces.

The Interfaces window opens.

3. Set

IPV6 Enable

. (See page A-7.)

4. If you have no other Interface parameters

to configure, click on

. Otherwise,

continue with the Interface configuration.

The Configuration Manager window

appears.

Table 3-1. PPP Modes

Connection Type PPP Mode Value Comments

Any nonmulitlink circuit Normal This is the default value for any nonmultilink

connection.

Multiline Normal Same as single-line connection.

Multilink Multilink

Monitor

• Set the PPP Mode parameter to Multilink

to configure the circuit for multilink

operation.

• Set it to Monitor if you want the local

router to serve as the congestion monitor

for the multilink circuit. Only one side of

any connection should be the monitor.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 151 152

Comentários a estes Manuais

Sem comentários

Avaya Configuring PPP Services Manual do Utilizador Página 65

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Avaya Configuring PPP Services