Avaya Configuring PPP Services Manual do Utilizador descarregar pdf (Página 57)

Customizing PPP

308639-14.00 Rev 00

3-3

For example, the following command enables IP routing on the interface with the

IP address of 1.1.1.1.

ip/1.1.1.1# state enable

Using Site Manager

To enable IP routing over this PPP interface, do the tasks in the following table.

The rest of this chapter describes how to configure and customize PPP for your

system. Follow the instructions that apply to your network requirements.

Site Manager Procedure

You do this System responds

1. From the Protocols menu, choose

PPP

. The Interfaces menu appears.

2. Choose

Interfaces.

The Interfaces window opens.

3. Set

IP Enable

Enable

. (See page A-3.)

4. If you have no other Interface parameters

to configure, click on

. Otherwise,

continue with the Interface configuration.

The Configuration Manager window

appears.

Note:

If you are using Site Manager and dynamically configuring a router that

has already negotiated its Link Control Protocol, you must force LCP

renegotiation on the interface to implement your changes. To do this, disable

and then reenable the corresponding network control protocol(s).You can

change as many parameters as you need to before forcing the renegotiation.

After making all your changes to any of the addressing or routing protocol

enabling parameters:

Set the corresponding network control protocol parameter (for

example, IP Enable) to Disable and, if necessary, apply the changes.

Reset the same parameter to Enable and, if necessary, apply the

changes.

Refer to the description of enabling specific protocols for details.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 151 152

Sem comentários

Avaya Configuring PPP Services Manual do Utilizador Página 57