Avaya Configuring PPP Services Manual do Utilizador descarregar pdf (Página 58)

Configuring PPP Services

3-4

308639-14.00 Rev 00

Setting Up Remote Addresses

Using Site Manager, you can define an address and node number (depending on

the requirements of the protocol you’ve chosen) that you want the remote peer to

use. That is, you can define an

•IP address

• IPX network number and node number

• AppleTalk node number

depending on the protocol you enable. After enabling the protocol, specify the

appropriate parameter(s) as described in the following sections.

Defining an IP Address for a Remote Peer

Use Site Manager to specify the IP address that the remote peer router should use.

The interface you’re configuring includes this address in its network control

protocol (NCP) negotiations. The default is 0.0.0.0, indicating that this is an

unnumbered interface. You can enter any valid IP address. (For information about

unnumbered IP interfaces and on configuring an adjacent host entry, see

Configuring IP, ARP, RARP, RIP, and OSPF Services.)

Beginning at the Configuration Manager window, complete the tasks in the

following table to specify an IP address for a remote peer.

Site Manager Procedure

You do this System responds

1. From the Protocols menu, choose

PPP

. The Interfaces menu appears.

2. Choose

Interfaces.

The Interfaces window opens.

3. Set the

Remote IP Address

(See page A-8.)

4. If you have no other Interface parameters

to configure, click on

. Otherwise,

continue with the Interface configuration.

The Configuration Manager window

appears.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 151 152

Sem comentários

Avaya Configuring PPP Services Manual do Utilizador Página 58