Avaya Configuring Dial Services Manual do Utilizador descarregar pdf (Página 97)

100

101

Starting Dial Backup Using the BCC

117353-B Rev. 00

3-11

Creating Dial Backup Service for ISDN Interfaces

Before creating a pool with ISDN lines, you need to select a port and designate it

as a BRI or PRI interface. Refer to the appropriate section for instructions:

• Configur

e BRI Lines on page 3-11

• Configure PRI Lines on page 3-13

Configure BRI Lines

ISDN/BRI Net Modules are available only on the Access Node (AN

), Access

Stack Node (ASN™), Access Node Hub (ANH™), Access Remote Node

(ARN™), and System 5000™ hardware platforms.

To configure BRI interfaces, you specify the interface for BRI service and what

type of service, for example, whether one or two B channels are available.

To configure a BRI object:

Begin by configuring the leased interface. See “Creating a Leased

Interface for Backup Service” on page 3-6 for instructions.

Create the interface for the backup BRI interface by entering:

bri

slot/connector

mode

mode_type

mode_type specifies whether the BRI line is operating as a dial-up line or

leased-line. Table 3-2

on page 3-12 lists the modes.

If you have a dial-up application, choose one of the dial-up modes. For

networks in Germany and Japan, if you want to have the dial-up line up at all

times and your ISDN switch can support permanent connections, select one of

the leased modes.

For example, for an interface with the default BRI service, 2 B-channels and

one D-channel, enter:

box# bri 3/1 mode 2b+d

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 481 482

Comentários a estes Manuais

Sem comentários

Avaya Configuring Dial Services Manual do Utilizador Página 97

Comentários a estes Manuais

Manuais e produtos relacionados com Software Avaya Configuring Dial Services