Avaya Configuring Dial Services Manual do Utilizador descarregar pdf (Página 67)

Starting Dial Services Using Site Manager

117353-B Rev. 00

2-11

Site Manager Procedure

You do this System responds

1. In the Configuration Manager window,

click on an MCT1 or MCE1 connector.

The Port Application window opens.

2. Set the

Port Application Mode

parameter

to

PRI

and click on

OK

. Click on

Help

or

see the parameter description on

page A-18.

You return to the Configuration Manager

window.

3. Repeat steps 1 and 2 for each PRI line you

want in the pool.

The Clock Parameters window opens.

The clock parameters define the timing

sources that apply to all connectors and

DS0 timeslots supported by the MCT1

and MCE1 link modules.

4. Click on

OK

. The MCT1 or MCE1 Port Parameters

window opens.

The port parameters apply to each of the

24 DS0 channels for MCT1 ports or 31

DS0 channels for MCE1 ports.

5. Click on

OK

.

In most cases, you can use the defaults for

MCT1 and MCE1 parameters. To modify

these values, see

Configuring WAN Line

Services

.

The PRI Logical Lines window opens.For

the first PRI interface you configure, the

Timeslots window opens immediately

following the PRI Logical Lines window.

Each PRI port supports up to 23 logical B

channels for MCT1 ports or 30 logical B

channels for MCE1 ports.

6. Choose Select All to change all timeslots

to B channels. If you purchased selective

PRI service from your ISDN provider, go to

step 7.

All the timeslots now read B Channel.

7. Optionally, if you purchased selective PRI

service from your ISDN provider, select

individual timeslots.

Select only the timeslots that the service

provider assigns to you. For example, if

your provider assigns you timeslots 1

through 10, select slots 1 through 10 in the

Timeslots window.

A timeslot menu opens.

(continued)

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 481 482

Comentários a estes Manuais

Sem comentários