Avaya Troubleshooting Routers Guia de Resolução de Problemas descarregar pdf (Página 110)

Troubleshooting Routers

6-4

Static Conﬁguration Conﬂict Event Message

The node number associated with the interface is already in use by another node

on the same segment.

Set the node number of the interface to 0 so that it will conﬁgure dynamically, or

deﬁne a unique node ID.

Troubleshooting DLSw

This section assumes that you have isolated a problem to DLSw. If not, refer to

Chapter 2 to determine whether these instructions apply to your problem.

You can turn on extended DLSw (Data Link Switch) log messages by setting the

Max Sessions attribute under wfDls to 1111. We recommend that you turn off

extended DLSw messages when you ﬁnish examining the log to test or

troubleshoot a DLSw connection.

Troubleshoot DLSw as follows:

1. Use the Events Manager or the Technician Interface to ﬁlter the log to

display messages of all severity levels for DLSw.

The Technician Interface command is

log -fftwid -eDLS -s

<slot_no.>

Example

If you are ﬁltering events from Slots 3 and 4, you enter

log -fftwid -eDLS -s3 -s4

Make sure that the DLSw MTU size matches the synchronous line MTU

size.

Unnecessary packet fragmentation can occur when these settings do not

match.

3. Use the Technician Interface or the Statistics Manager to inspect the

global source-route bridge settings, such as the internal LAN ID, the

group LAN ID, and the bridge ID. If you are using the Technician

Interface, enter the following command:

get wfBrSr.*.0

1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 253 254

Sem comentários

Avaya Troubleshooting Routers Guia de Resolução de Problemas Página 110