Avaya BCM 4.0 Networking Guia de Configuração descarregar pdf (Página 546)

100

101

546 Chapter 62 Configuring the Dial-up resources

N0060606N0060606

1 Click Configuration > Resources > Network Interfaces > Interfaces tab.

2 Click the Modem interface to configure.

3 Click the Link Parameters tab.

The Link Parameters panel appears. See Figure 168.

4 Configure the Modem Link Parameters. Refer to the information in Table 123.

Figure 168 Link Parameters

Table 123 Modem link parameters (Sheet 1 of 2)

Attribute Value Description

Link Parameters

Dial-out number <numeric> Type a telephone number to use to connect using the modem interface. If

needed, include area codes and all necessary digits to dial an external

number.

Maximum receive

unit

<128-16384> The largest incoming packet size the modem will handle.

Default: 1500.

Maximum

transmission unit

<128-16384> Maximum size of the packets that will be sent.

Default: 1500.

Disconnect time (s) <numeric> Enter the interval, in seconds, during which the modem interface

disconnects when there is no traffic.

Select 0 if you want the BCM to close the connection when the far end

hangs up.

Specifying a value of 0 makes the connection persistent.

Note: If you have more than one Trap Community Entry configured with

this dial up interface, using a very small number for the Disconnect Time

will put you at risk of a racing condition. To reduce the racing condition,

enter a larger value for the Disconnect Time.

Advanced Parameters

Connect rate 57600

38400

19200

9600

4800

Specify the initial speed (in bits per second) for the modem to connect.

Set to the maximum permissible value for best results.

Note: This is the initial rate; the actual rate is always negotiated.

Default: 57600

1 2 ... 541 542 543 544 545 546 547 548 549 550 551 ... 757 758

Comentários a estes Manuais

Sem comentários

Avaya BCM 4.0 Networking Guia de Configuração Página 546

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Avaya BCM 4.0 Networking