Avaya BCM 4.0 Networking Guia de Configuração Página 274

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 758
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 273
274 Chapter 24 Dialing plans
N0060606N0060606
Provisioning for Call by Call limits with PRI
To program the system for Call by Call Limits with a PRI interface, you must:
provision a DTM as PRI, if one is not already configured as part of the system
select a protocol
program incoming call routing
program routes that use the PRI pools, see “Configuring call routing” on page 270.
Other required programming in the Element Manager
Programming Call by Call on PRI requires these settings:
Select Configuration > Sets > All DNs, and assign the line pool.
Select Configuration > Telephony > Dialing Plan > Routing, assign a pool for routing, and
assign the service type and service id, if required.
Select Configuration > Telephony > Dialing Plan > General, and specify the minimum and
maximum values for the pools.
Call by Call service routing
Table 55 is an example of a Routing Table containing Call by Call programming (available in the
North America market profile). Also refer to “Configuring Call-by-Call services” on page 271.
The service identifier (SID) depends on the selected service type (for example, with
NI-2 protocol).
Table 55 Call by Call routing table example
Route Number
(000-999)
Dial Out
(24 digits) Use Pool Service Type
Service
Identifier
003 BlocA Public
004 BlocA FX xxxxx
005 BlocA TIE xxxxx
006 BlocB OUTWATS xxx
007 BlocB Private
008 BlocB Switched Digital
Note: The public DN lengths are used for all PRI calls except those whose routes use service type Private or service
type TIE with DN Type specified as Private.
Note: This type of routing only applies to those PRI trunks set with a
protocol of NI, DMS100, DMS250 or 4ESS.
Vista de página 273
1 2 ... 269 270 271 272 273 274 275 276 277 278 279 ... 757 758

Comentários a estes Manuais

Sem comentários