
199
BCM 4.0 Networking Configuration Guide
Chapter 15
Configuring lines: T1-Digital Ground Start
The following describes how to configure T1-Digital Ground Start lines.
The following paths indicate where to access the Ground Start lines through Element Manager and
through Telset Administration:
• Element Manager: Configuration > Telephony > Lines
• Telset interface: **CONFIG > Lines
Prerequisites
Complete the following prerequisites checklist before configuring the modules.
Process map
Figure 66 and Figure 67 provide an overview of the line features for Ground Start lines.
Task: Configure ground start lines connected to the system
• “Configuring digital ground start line features” on page 202
DTM module is installed and configured. Refer to “Trunk Module Parameters” on
page 124.
Lines are provisioned. Refer to “Provisioning module lines/loops” on page 132.
Comentários a estes Manuais