Avaya IP500 V2 Instruções de Operação descarregar pdf (Página 46)

Installing IP500/IP500 V2 Page 46

15-601042 Issue 28g (11 October 2013)IP Office 9.0

1.11 Wall and Rack Mounting

All the IP Office control units are designed to be free-standing. On systems with external expansion modules, the control

unit and modules are intended to be stacked.

Using additional option mounting kits, some systems can be wall or rack mounted.

Control/Expansion Unit

Wall Mount

Rack

Mount

IP500 Control Unit

IP500 V2 Control Unit

IP500 External Expansion Modules

IP400 External Expansion Modules

–

Wall Mounting

IP500, IP500 V2 control units and IP500 external expansion modules can be wall or rack mounted. To do this, a wall

mounting kit is required in addition to suitable wall fixings.

In addition to the existing environmental requirements for an IP Office system, the following additional requirements

apply when wall mounting a unit:

· The wall surface must be vertical, flat and vibration free. Attachment to temporary walls is not supported.

· Only the screws provided with the mounting kit should used to attach the brackets to the control unit.

The following wall and rack mounting kit is currently available:

· IPO IP500 RACK MNTG KIT V3 (SAP Code 700503160)

These kits can be used for wall and rack mounting of an IP500 or IP500 V2 control unit and IP500 external

expansion modules. The kits incorporates cable routing at the front and rear of the unit. For wall mounted control

units it allows orientation of the control unit base card slots to the left or to the right.

Rack Mounting

All IP Office control units and external expansion modules can be rack mounted into standard 19" rack systems. Each unit

requires a 2U slot space within the rack. The IPO IP500 RACK MNTG KIT V3 is used for rack mounting of units.

Where IP Office systems are being rack mounted, the effect of conditions within the rack cabinet must be considered. For

example the rack temperature may be above the room temperature and airflow within the rack will be restricted. The

environmental requirements for the individual IP Office units are still applicable inside the rack cabinet.

Barrier Box Rack Mounting Kit

· Barrier Box Rack Mounting Kit (SAP 700293905)

Barrier boxes must be used for out-of-building analog phone

extensions . This bracket allows up to 8 IP Office barrier boxes to

be rack mounted and simplifies the number of connections to the

protective ground point in the rack. This kit must be used when more

than 3 barrier boxes are in use and supports a maximum of 16

barrier boxes for a single external expansion module.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 441 442

Sem comentários

Avaya IP500 V2 Instruções de Operação Página 46