Avaya IP500 V2 Instruções de Operação descarregar pdf (Página 222)

Installing IP500/IP500 V2 Page 222

15-601042 Issue 28g (11 October 2013)IP Office 9.0

10.3.3 ATM Combination Card

These cards are used to add a combination of ports to an IP500 V2 control unit. Not supported by IP500 control units.

The newer IP500 ATM Combination Card V2 version is supported by IP Office Release 8.1 Feature Pack 1 and higher

only.

· Supports

· 10 voice compression channels. Codec support is G.711, G729a

and G.723 with 64ms echo cancellation. G.722 is supported by

IP Office Release 8.0 and higher.

· 6 Digital Station ports for digital stations (except 3800,

4100, 4400, 7400, M and T-Series).

· 2 Analog Extension ports.

· 4 Analog Trunk ports:

Depending on the version of combination card, V1 or V2, the

analog trunk daughter card is equivalent to an IP500 Analog

Trunk Card 4 V1 or V2 respectively.

· IP500 Control Unit:

· IP500 V2 Control Unit:

· Maximum per Control Unit: 2 combination cards of any type per

IP500 V2 control unit.

· IP500 Trunk Card Support: 1. The trunk daughter card is pre-

installed and cannot be replaced with another card type.

· IP Office Software Level: 6.0+.

This depends on the version of the card as follow:

· V1: 6.0+. New build PCS04 cards are only supported in systems

running IP Office Release 6.1(20), 7.0(12) or 8.0 and higher.

Refer to IP Office Technical Tip 237.

· V2: IP Office Release 8.1 Feature Pack 1 or higher.

Port Type

Ports

Features

Digit Station

1 to 6

Provides DS ports for digital stations (except 4100, 4400, 7400, M and T-Series).

LEDs

· Green Flashing = Phone detected.

· Green On = Phone active.

· LED1 is also used for base card status:

· Red On = Error

· Red Slow Flash = Initializing.

· Red Flash every 5 seconds = Card

okay.

· Red Fast Flash = System shutdown.

Analog

Extension

7 to 8

· Supports ICLID modes DTMFA, DTMFC, DTMFD, FSK and UK20.

· REN 2 (1 for external bell device).

· Off-Hook current: 25mA

· Ring Voltage: 40V.

· Intended for connection to two-wire analog phones, the ports do not include a ringing

capacitor. For connection to 4-wire analog phones, connection should be via a master

socket with ringing capacitors.

· During power failure extension port 8 is connected to the analog trunk port 12.

· No status LEDs are used for analog phone extensions.

Analog Trunk

9 to 12

· DTMF, ICLID and busy tone detection.

· Over-voltage/lightning protection (may still require additional protection equipment )

· DTMF and LD (loop disconnect) dialing.

· Echo cancellation.

LEDs

· Green on = V1: Card installed. V2: Line connected to the port but idle.

· Green flashing = Line in use.

· LED 9 is also used for daughter card status.

· Red On = Error

· Red Slow Flash = Initializing.

· Red Flash every 5 seconds = Card

okay.

236

394 48

1 2 ... 217 218 219 220 221 222 223 224 225 226 227 ... 441 442

Comentários a estes Manuais

Sem comentários

Avaya IP500 V2 Instruções de Operação Página 222

Comentários a estes Manuais

Manuais e produtos relacionados com Gateways/controladores Avaya IP500 V2