Avaya IP500 V2 Instruções de Operação Página 225

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 442
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 224
Installing IP500/IP500 V2 Page 225
15-601042 Issue 28g (11 October 2013)IP Office 9.0
System Components: IP500 Base Cards
10.3.4 BRI Combination Card
This card is used to add a combination of ports to an IP500 V2 control unit. Not supported by IP500 control units.
· Supports
· 10 voice compression channels. Codec support is G.711, G729a
and G.723 with 64ms echo cancellation. G.722 is supported by
IP Office Release 8.0 and higher.
· 6 Digital Station ports for digital stations (except 3800,
4100, 4400, 7400, M and T-Series).
· 2 Analog Extension ports.
· 2 BRI Trunk ports (4 BRI channels).
· 10 voice compression channels. Codec support is G.711, G729a
and G.723 with 64ms echo cancellation. G.722 is supported by
IP Office Release 8.0 and higher.
· IP500 Control Unit:
· IP500 V2 Control Unit:
· Maximum per Control Unit: 2 combination cards of any type.
· IP Office Basic Edition - Norstar Mode and IP Office Basic Edition
systems are limited to a maximum of 12 BRI channels using BRI
Combination and or BRI trunk daughter cards.
· IP500 Trunk Card Support: 1. The trunk daughter card is pre-
installed and cannot be replaced with another card type.
Port Type
Ports
Features
Digit Station
1 to 6
Provides DS ports for digital stations (except 4100, 4400, 7400, M and T-Series).
LEDs
· Green Flashing = Phone detected.
· Green On = Phone active.
· LED1 is also used for base card status:
· Red On = Error
· Red Slow Flash = Initializing.
· Red Flash every 5 seconds = Card
okay.
· Red Fast Flash = System shutdown.
Analog
Extension
7 to 8
· Supports ICLID modes DTMFA, DTMFC, DTMFD, FSK and UK20.
· REN 2 (1 for external bell device).
· Off-Hook current: 25mA
· Ring Voltage: 40V.
· Intended for connection to two-wire analog phones, the ports do not include a ringing
capacitor. For connection to 4-wire analog phones, connection should be via a master
socket with ringing capacitors.
· No status LEDs are used for analog phone extensions.
BRI Trunk
9 to 10
· Each trunk port supports 2B+D channels.
· ETSI or AusTS013 basic rate protocol set through the IP Office configuration.
LEDs
· Off = No trunk present.
· Green on = Trunk present.
· Green flashing = Trunk in use.
· LED 9 is also used for daughter card status.
· Red On = Error
· Red Slow Flash = Initializing.
· Red Flash every 5 seconds = Card
okay.
· Red Fast Flash = System shutdown.
Not Used
11 to 12
Name
Description
SAP Code
IPO IP500 V2 COMB CARD BRI
IPO IP500 V2 COMBINATION CARD BRI
700476021
48
394 48
Vista de página 224
1 2 ... 220 221 222 223 224 225 226 227 228 229 230 ... 441 442

Comentários a estes Manuais

Sem comentários