Installing IP500/IP500 V2 Page 221
15-601042 Issue 28g (11 October 2013)IP Office 9.0
System Components: IP500 Base Cards
10.3.2 Analog Phone
This card is used to add analog phone ports to an IP500 and IP500 V2 control unit. It is available in two variants,
providing either 2 or 8 analog extension ports.
· Supports
Provides either 8 or 2 analog phone ports depending on card
variant.
· IP500 Control Unit:
· IP500 V2 Control Unit:
· Maximum per Control Unit: 4.
· IP500 Trunk Card Support: 1.
· Supports ICLID modes DTMFA, DTMFC, DTMFD, FSK and UK20.
· REN 2 (1 for external bell device).
· Off-Hook current: 25mA
· Ring Voltage: 40V.
· Intended for connection to two-wire analog phones, the ports do not include a ringing
capacitor. For connection to 4-wire analog phones, connection should be via a master
socket with ringing capacitors.
· If fitted with an analog trunk card, for the Phone 8, during power failure extension port
8 is connected to the analog trunk port 12.
Port LEDs
· No status LEDs are used for analog phone extensions.
· LED1 is also used for base card status:
· Red On = Error
· Red Slow Flash = Initializing.
· Red Flash every 5 seconds = Card
okay.
· Red Fast Flash = System shutdown.
The card can be fitted with one trunk daughter card of any type. The trunk daughter card
then uses ports 9 to 12 on the base card for its trunk connections.
Port LEDs
LED use depends on the type of daughter card installed on the base card:
· LED 9 is also used for daughter card status.
· Red On = Error
· Red Slow Flash = Initializing.
· Red Flash every 5 seconds = Card
okay.
· Red Fast Flash = System shutdown.
· Green on = V1: Card installed. V2: Line connected to the port
but idle.
· Green flashing = Line in use.
· Off = No trunk present.
· Green on = Trunk present.
· Green flashing = Trunk in use.
· Red/Green Fast Flash (port 9) or Green Fast Flash (port
10) = Alarm indication signal (AIS) from the trunk remote
end.
· Red with Green Blink (port 9) or Green Blink (port 10) =
Port in loopback mode (set through IP Office System Monitor).
· Off = No trunk present.
· Green on = Trunk present.
· Green flashing = Trunk in use.
IPO 500 Extn Card Phone 2
IP Office 500 Extension Card Phone 2
IPO 500 Extn Card Phone 8
IP Office 500 Extension Card Phone 8
391
Comentários a estes Manuais