Avaya IP500 V2 Instruções de Operação descarregar pdf (Página 424)

Installing IP500/IP500 V2 Page 424

15-601042 Issue 28g (11 October 2013)IP Office 9.0

11. Safety Statements

The Avaya IP400 Office and IP500 Office modules are intended to be installed by 'Service Personnel' and it is the

responsibility of the Service Personnel to ensure that all subsidiary interconnected equipment is wired correctly and also

meet the safety requirements of IEC60950 or UL60950 where applicable.

The CE mark affixed to this equipment means that the module complies with the 1999/5/EC (R&TTE), 89/336/EEC

(EMC) and 72/23EEC (LVD) Directives.

· The Declarations of Conformity (DoC) for the IP400 and IP500 products are available on the IP Office Application

DVD.

· This warning symbol is found on the base of IP500 modules.

· Refer to Trunk Interface Modules for information concerning which Trunk Interface module variants are fitted

in which country.

In Finland, Norway and Sweden a protective earthing conductor must be attached to the protective earth point on the

rear of the IP500 and IP500 V2 Servers. See Grounding for more information. In addition the Server must be located

in a restricted access location where equipotential bonding has been applied, for example, in a telecommunication centre.

11.1 Lithium Batteries

A lithium battery is fitted to the real time clock on IP Office IP400 control unit motherboards and the IP500 control unit

motherboard. .

WARNING

The Lithium battery must only be replaced by Avaya personnel or authorized representatives. There is a danger of

explosion if the battery is incorrectly replaced. Replace only with the same or equivalent type recommended by the

manufacturer. Dispose of used batteries according to the manufacturer's instructions.

11.2 Lightning Protection/Hazard Symbols

Lightning protectors

The buildings lightning protectors must be verified as follow:

1.Check the lightning protectors, at the trunk cable entry point to the building housing the Avaya IP Office, paying

special attention to the lightning protection grounding. Report any problems, in writing, to the telephone company.

2.Equipment that is designed to be connected using internal wiring is typically not lightning protected. Hence, Avaya

IP Office extension cabling must not leave the building. For installations where telephones and/or other standard

(tip/ring) devices are installed in another building then lightning protection is required (see Out of Building

Telephone Installations ).

Hazard Symbol

The shock hazard symbol is intended to alert personnel to electrical hazard or equipment damage. The following

precautions must also be observed when installing telephone equipment:

1.Never install telephone wiring during a lightning storm.

2.Never install telephone jacks in wet locations unless the jack is specifically designed for wet locations.

3.Never touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the

network interface.

4.Always use caution when working with telephone lines.

425

1 2 ... 419 420 421 422 423 424 425 426 427 428 429 ... 441 442

Sem comentários

Avaya IP500 V2 Instruções de Operação Página 424