Avaya IP500 V2 Instruções de Operação descarregar pdf (Página 208)

Installing IP500/IP500 V2 Page 208

15-601042 Issue 28g (11 October 2013)IP Office 9.0

9.14 Grounding

Use of ground connections reduces the likelihood of problems in most telephony and data systems. This is especially

important in buildings where multiple items of equipment are interconnected using long cable runs, for example phone

and data networks.

All IP Office control units and external expansion modules must be connected to a functional ground. Where the unit is

connected to a power outlet using a power cord with an earth lead, the power outlet must be connected to a protective

earth.

In some cases, such as ground start trunks, in addition to being a protective measure this is a functional requirement for

the equipment to operate. In other cases it may be a locale regulatory requirement and or a necessary protective step,

for example areas of high lightning risk.

· WARNING

During installation do not assume that ground points are correctly connected to ground. Test ground points before

relying on them to ground connected equipment.

· Additional protective equipment

In addition to grounding, additional protective equipment will be required in the following situations.

· On any Digital Station or Phones external expansion module connected to an extension located in another

building. Refer to "Out of Building Telephone Installations ".

· In the Republic of South Africa, on all Analog Trunk external expansion modules (ATM16) and on any control

units containing an analog trunk cards (ATM4/ATM4U).

Tools Required

· o M4 Cross-Head Screwdriver.

· o Tools suitable for crimping a cable spade.

Parts and Equipment Required

· o 14AWG Solid copper wire for ground connection.

· o Cable sleeve matching local regulator requirements. Typically green for a functional ground and green/yellow for

a protective ground.

The ground point on IP Office control units and expansion modules are marked with a or symbol. Ground

connections to these points should use a 14 AWG solid wire with either a green sleeve for a functional ground or green

and yellow sleeve for a protective ground.

IP500/IP500 V2 Control Unit

On IP500 and IP500 V2 control units the ground point is located above the RS232 DTE port.

External Expansion Modules

On expansion modules, the ground point is a 4mm screw located towards the right on the rear of the module.

· On some older modules, the dedicated ground point screw is not present. In those cases, the top-center cover

fixing screw (3mm) can be used as an alternative ground connection point. A toothed washer should be added to

ensure good contact.

1 2 ... 203 204 205 206 207 208 209 210 211 212 213 ... 441 442

Sem comentários

Avaya IP500 V2 Instruções de Operação Página 208