Avaya Configuring IP Services Manual do Utilizador descarregar pdf (Página 130)

100

101

Configuring IP Services

3-8

Conﬁguring RIP on the Router

Before you can conﬁgure RIP on the router, you must perform the following

operations to ensure that the slot is properly set up for IP:

1. Open a conﬁguration ﬁle.

2. Specify a slot and conﬁgure a link module on the slot (if the conﬁguration ﬁle

is a local mode ﬁle).

3. Select a link or net module connector and conﬁgure a circuit on the connector,

or conﬁgure a WAN circuit if this connector requires one.

For instructions on performing these operations, see Conﬁguring Routers.

Once you have conﬁgured a circuit, you are ﬁnished with the Add Circuit window.

1. Click on OK on the Add Circuit Window.

The Select Protocols window opens.

2. Select IP and RIP from the Select Protocols window and click on OK.

Site Manager displays the IP Conﬁguration window.

3. Edit the IP window as described in “Conﬁguring a Circuit and Adding an

IP Interface” on page 2-32.

4. Click on OK.

RIP is conﬁgured on the interface with default parameters. To customize a RIP

interface, begin at the Conﬁguration Manager window and proceed as follows:

1. Select Protocols➔IP➔RIP Interfaces.

The IP RIP Interfaces window opens (see Figure 3-1). It lists all RIP

interfaces conﬁgured on the router.

2. Click on the RIP interface you want to edit.

3. Edit those parameters you want to change.

4. Click on Apply to implement your changes.

5. Click on Done to save your changes and exit the window.

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 465 466

Comentários a estes Manuais

Sem comentários

Avaya Configuring IP Services Manual do Utilizador Página 130

Comentários a estes Manuais

Manuais e produtos relacionados com Software Avaya Configuring IP Services