
Using Technician Interface Software
2-2
308657-14.00 Rev 00
Overview
You access the Technician Interface software through a console or modem
attached to a router serial port. The number of Technician Interface sessions you
can establish for a router depends on the number of serial ports available on that
router.
• The SRM-L board has one serial port (labeled “Console”), allowing you to
establish one session on a Backbone Node platform.
• The AN processor board has one serial port (labeled “Console”), allowing you
to establish one session.
• The ARN base module has up to three serial ports (one labeled “Console,”
one labeled “Modem,” and an optional V.34 modem interface), allowing you
to establish one session.
• The ASN base board has one serial port per router, with up to four routers
stacked, allowing you to establish up to four sessions with the interconnected
stack.
See Configuring and Managing Routers with Site Manager if you prefer to use
Site Manager to configure the serial port parameters for the router console.
Configuring Console Port Parameters
The following sections describe how to use the following Technician Interface
commands:
• list
• set
• commit
•save
Using the list Command
You can list and review all serial port attributes by entering the following
command line at the Technician Interface prompt:
list wfSerialPortEntry
Comentários a estes Manuais