Avaya Using Technician Interface Software Manual do Utilizador descarregar pdf (Página 104)

Using Technician Interface Software

4-12

308657-14.00 Rev 00

Transferring a File

Depending on conditions existing within your network, you can transfer files

between Nortel Networks routers and remote workstations using either of two

methods:

• In-band (using Technician Interface

tftp

commands and a route through your

high-speed, IP network)

• Out-of-band (using Technician Interface

xmodem

commands and a route

through a lower-speed, dial network)

You can transfer a file in-band whenever

• You can dial in to the Technician Interface port of a router you choose as

source or destination for a file transfer operation.

• An operational IP routing path exists through your network, between the file

source (a router or a remote workstation) and the file destination (also a router

or a remote workstation).

Out-of-band file transfers are typically a less efficient but sometimes useful

method, for example, for router diagnosis and management. You use this method

most beneficially when

• You can dial in to the Technician Interface port of a router you choose as the

source or destination for a file transfer operation.

• All IP routing paths between the file source and the file destination are down

(nonoperational).

You can use either a UNIX or PC remote workstation to transfer files in-band or

out-of-band using Technician Interface

xmodem

commands, as operating

conditions within your network allow.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 343 344

Sem comentários

Avaya Using Technician Interface Software Manual do Utilizador Página 104