Avaya Using Technician Interface Software Manual do Utilizador descarregar pdf (Página 311)

Using Syslog Messaging to Monitor Router Events

308657-14.00 Rev 00

C-23

$: set wfSyslogEntFltrEntry.wfSyslogEntFltrDisable.

<wfSyslogEntFltrHostIndex>.<wfSyslogEntFltrNum>.

2;commit

Disabling a filter:

-- Transitions the operational state of that filter

(wfSyslogEntrFltrOperState) to INACTIVE

-- Stops Syslog from forwarding event messages through that filter

• Reenable an entity filter by entering the following command line:

$: set wfSyslogEntFltrEntry.wfSyslogEntFltrDisable.

<wfSyslogEntFltrHostIndex>.<wfSyslogEntFltrNum>.

1;commit

Reenabling a filter:

-- Transitions the operational state of that filter

(wfSyslogHostOperState) to ACTIVE

-- Allows Syslog to resume forwarding event messages through that

filter

Deleting Remote Hosts or Entity Filters from the Syslog Configuration

You can delete a remote host from the Syslog host table, or delete a filter from the

Syslog filter table, as follows:

To delete a remote host entry from the Syslog host table, enter the

following command line:

$: set wfSyslogHostEntry.wfSyslogHostDelete.

2;commit

To delete a filter from the Syslog Entity Filter table, enter the following

command line:

$: set

wfSyslogEntFltrEntry.wfSyslogEntFltrDelete.

<wfSyslogEntFltrHostIndex>.

2;commit

Save the changes to your configuration. (See Task 8 on page C-20.)

1 2 ... 306 307 308 309 310 311 312 313 314 315 316 ... 343 344

Sem comentários

Avaya Using Technician Interface Software Manual do Utilizador Página 311