Avaya Using Technician Interface Software Manual do Utilizador descarregar pdf (Página 312)

Using Technician Interface Software

C-24

308657-14.00 Rev 00

Deleting Syslog from the Router

If you want to delete Syslog from the router, change the setting for

wfSyslogDelete, a global parameter/attribute, as follows:

$:set wfSyslog.wfSyslogDelete.0 2;commit

Example Syslog Configuration

The following is an example of a Syslog configuration procedure when:

• Your management workstation has an IP address of 192.32.6.14.

• You want to receive at your management workstation messages for all

software entities running on a particular Nortel Networks router. (This is a

wildcard configuration scenario.)

• You want to create and enable Syslog on a model BLN router.

• You want to capture all fault, warning, and debug level messages from the

router.

• You want to capture only messages logged on slots 2 to 4 of the router.

Proceed as follows:

Define a slot mask for Syslog on the router:

$: set wfProtocols.wfSYSLLoad.0 0x7FFE0000;commit

The hexadecimal number 7FFE0000 converts to the binary number

0111 1111 1111 1110 0000 0000 0000 0000. The most significant bit

position of the binary number represents slot 1. The bit positions in

descending order of significance represent slots 2, 3, 4, and so on.

Create the Syslog base record on the router:

$: set wfSyslog.1.0 1;commit

Create a host record for 192.32.6.14:

$: set wfSyslogHostTable.wfSyslogHostEntry.1.192.32.6.14 1;commit

Note:

When you create a host record, the log facility defaults to a value of 184

(Local7).

1 2 ... 307 308 309 310 311 312 313 314 315 316 317 ... 343 344

Sem comentários

Avaya Using Technician Interface Software Manual do Utilizador Página 312