Avaya Using Technician Interface Software Manual do Utilizador descarregar pdf (Página 308)

Using Technician Interface Software

C-20

308657-14.00 Rev 00

The default value of wfSyslogEntFltrWarningMap is 5, mapping router

WARNING level messages to UNIX system level WARNING messages.

• Change router INFO message mapping, as follows:

$: set wfSyslogEntFltrEntry.wfSyslogEntFltrInfoMap.

<host_IP_address>

<entity_code>

<filter_index>

<1 - 8>

The default value of wfSyslogEntFltrInfoMap is 7, mapping router INFO

level messages to UNIX system level INFO messages.

• Change router TRACE message mapping, as follows:

$: set wfSyslogEntFltrEntry.wfSyslogEntFltrTraceMap.

<host_IP_address>

<entity_code>

<filter_index>

<1 - 8>

The default value of wfSyslogEntFltrTraceMap is 3, mapping router

TRACE level messages to UNIX system level CRIT messages.

• Change router DEBUG message mapping, as follows:

$: set wfSyslogEntFltrEntry.wfSyslogEntFltrDebugMap.

<host_IP_address>

<entity_code>

<filter_index>

<1 - 8>

The default value of wfSyslogEntFltrDebugMap is 8, mapping router

DEBUG level messages to UNIX system level DEBUG messages.

Task 7: Adding More Hosts or Entity Filters

If you have finished adding entity filters for this remote host, and you do not want

to add another remote host at this time, go to Task 8. Otherwise, to add more hosts

or entity filters to your Syslog configuration:

• To add another entity filter for the same remote host, return to “Adding an

Entity Filter for a Remote Host” on page C-17

• To add another remote host to receive Syslog messages from the router, return

to “Adding a Remote Host to the Syslog Host Table” on page C-16

Task 8: Saving Your Syslog Configuration on the Router

Save to a file on an NVFS volume the Syslog additions to your configuration, as

follows:

save config

<vol>

1 2 ... 303 304 305 306 307 308 309 310 311 312 313 ... 343 344

Sem comentários

Avaya Using Technician Interface Software Manual do Utilizador Página 308