
Configuring WAN Line Services
2-20
117345-B Rev. 00
Setting the Signaling Method
You can specify the signaling method that the router uses for this line using the
Sync Media Type parameter. Available media types are as follows:
• Default
•T1
•E1
• RAISEDTR
• V25BIS
• ISDN BRI
• ISDNLEASEDLINE
• HAYES
Set the media type for the interface.
Using Site Manager
See the Sync Media Type parameter on page A-66 for information.
Enabling or Disabling DSR Polling
By default, a synchronous interface does not monitor the data set ready (DSR)
signal. If you set this parameter to Enable, the synchronous driver is enabled when
the DSR is detected. When the DSR is no longer detected, the driver is disabled.
Enable this parameter only if you plan to use dial-up services.
Enable or disable synchronous polling of DSR for the interface.
Using Site Manager
See the Sync Polling parameter on page A-68 for information.
Comentários a estes Manuais