Avaya Configuring WAN Line Services Manual do Utilizador descarregar pdf (Página 48)

Configuring WAN Line Services

2-14

117345-B Rev. 00

Disable this parameter on the synchronous interface that is either running at a

lower clock speed or carrying lower-priority traffic. If disabling Burst Count on

only one DSDE interface does not eliminate errors on both Ethernet interfaces,

then disable the Burst Count parameter on both interfaces.

Using the BCC

burst-count

variable

For example:

sync/4/1# burst-count enabled

sync/4/1# burst-count disabled

Using Site Manager

See the Burst Count parameter on page A-60 for information.

Specifying the Link-Level Protocol

The Service parameter specifies the link-level protocol for this interface. You can

set the link-level protocol to one of the following:

• Transparent

• LLC1

• LAPB

The synchronous interface is configured for LLC1 by default.

Setting this parameter to Transparent enables raw HDLC mode. LLC1 specifies

connectionless datagram service; it inserts the HDLC address and control fields at

the beginning of the frame.

If X.25 is enabled on this line, this parameter must be set to LAPB. See “Setting

the IFTF Pattern” later in this chapter.

Set the link-level protocol for the interface.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 293 294

Sem comentários

Avaya Configuring WAN Line Services Manual do Utilizador Página 48