Avaya Configuring WAN Line Services Manual do Utilizador descarregar pdf (Página 180)

Configuring WAN Line Services

8-20

117345-B Rev. 00

• 2e20

• 2e23

• 2e23 Inverted

For more information about running BERT diagnostics, see “Testing FT1

Lines” on page 8-22

See the BERT Test Pattern parameter on page A-54

for information.

Configuring NRZI Line Encoding

You can configure the NRZI Enable and NRZI type parameters. If applicable, see

“Configuring a Non-PRI Logical Line” on page 8-12

When enabled, the NRZI Enable parameter specifies nonreturn to zero inverted

(NRZI) line encoding to communicate state changes between the subscriber’s

devices across the frame relay network. You can disable communication of such

state changes by setting this parameter to Disable.

See the NRZI Enable parameter on page A-54

for information.

The NRZI Type parameter specifies the NRZI encoding format in the frame on the

logical line. Ignore NRZI Type if you set NRZI Enable to Disable.

Valid options are as follows:

• Mark -- This format uses a 0-bit to indicate a state change and a 1-bit to

indicate no state change.

• Space -- This format uses a 1-bit to indicate a state change and a 0-bit to

indicate no state change.

See the NRZI Type parameter on page A-55

for information.

1 2 ... 175 176 177 178 179 180 181 182 183 184 185 ... 293 294

Sem comentários

Avaya Configuring WAN Line Services Manual do Utilizador Página 180