Avaya Configuring Line Services Manual do Utilizador Página 180

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 301
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 179
Managing Line Resources
114078 Rev. A 8-7
Setting the Estimated Bandwidth
To activate resource reservation, enter the portion of this line’s bandwidth to make
available for ST2 requests for guaranteed service.
Enter an estimated total bandwidth for this line, from 0 through 214748364 bits/s.
To enable line resource management, enter a value greater than zero.
For point-to-point lines, you can usually enter the total line speed.
For an Ethernet line, you must estimate a value, because shared-media lines may
not have all of the bandwidth available. Base the estimate on line statistics, the
number of connected workstations, or other site-specific information.
You can set the Estimated Bandwidth for this interface.
Setting the Reservable Bandwidth
To enable ST2 reservable resources, specify the portion of this line’s bandwidth to
make available for ST2 requests for guaranteed service. The value can be any
value from 0 through 214748364 bits/s, and must be less than the value of the
Estimated Bandwidth parameter.
You can set the Reservable Bandwidth for this interface.
Specifying the Traffic Queuing Algorithm
By default, LRM uses best-effort scheduling for all reserved traffic. The resource
reservation protocol (ST2) controls admission of flows to the network, but does
not explicitly schedule each flow’s packets.
Site Manager: Estimated Bandwidth parameter: page A-75
Caution: Never make all available bandwidth reservable. Leave at least 15
percent of bandwidth available for network management, routing protocols,
and other best-effort traffic.
Site Manager: Reservable Bandwidth parameter: page A-75
Vista de página 179
1 2 ... 175 176 177 178 179 180 181 182 183 184 185 ... 300 301

Comentários a estes Manuais

Sem comentários