Avaya Configuring Line Services Manual do Utilizador Página 109

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 301
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 108
Configuring Line Services
5-14 114078 Rev. A
We recommend that you enable BofL for point-to-point connections between Bay
Networks peers. However, if such a connection is accomplished through a
wide-area transport service such as Frame Relay, X.25, or SMDS, you must
disable BofL.
You can disable and reenable BofL messages on the interface.
Setting the BofL Timeout
The BofL Timeout parameter specifies the time between transmissions of Breath
of Life messages from this synchronous interface.
This parameter is valid only if you set BofL to Enable. By default, the BofL
timeout is set to 5 seconds.
Timeout will occur if five periods elapse without both a successful frame
transmission and a successful reception. When timeout occurs, the router disables
and reenables the synchronous line. For example, with this parameter set to 5
seconds, the interface must successfully transmit and receive a frame within 25
seconds. Timeout occurs in 25 seconds.
You can set the BofL timeout to a value from 1 through 60 seconds on the
interface.
Setting the Maximum Transmission Unit (MTU)
The MTU parameter specifies the largest frame that the router can transmit on this
line. The MTU is 1600 bytes by default.
You can set the MTU from 3 through 4608 bytes on the interface.
For X.25, use a value at least 5 bytes more than the maximum packet size for the
packet level.
Site Manager: BofL parameter: page A-55
Site Manager: BofL Timeout parameter: page A-56
Site Manager: MTU parameter: page A-56
Vista de página 108
1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 300 301

Comentários a estes Manuais

Sem comentários