Avaya Configuring DLSw Services Manual do Utilizador Página 45
- Página / 256
- Índice
- RESOLUÇÃO DE PROBLEMAS
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Data Link Switching Overview
114063 Rev. A 1-19
Bay Networks provides two ways to communicate directly with an SNA processor
(such as an IBM 3745 or AS/400) over Frame Relay:
• Boundary Network Node (RFC 1490)
• Boundary Access Node
Boundary Network Node (RFC 1490)
The Boundary Network Node (BNN) refers to RFC 1490, Routed SNA over
Frame Relay. This implementation of LLC2 also complies with the Frame Relay
Forum 3 (FRF.3), “Multiple Protocol Encapsulation over Frame Relay
Implementation Agreements,” which defines how SNA traffic traverses a Frame
Relay network.
BNN allows native SNA traffic (originating from SDLC, LAN- or WAN-attached
devices) to communicate over public or private Frame Relay networks directly
with an SNA processor. Devices can communicate with intermediate routing
nodes, or in a single-switch configuration function as a Frame Relay Access
Device (FRAD).
Since BNN does not carry the destination and source MAC addresses in the
network packets, the BNN format carries the fewest number of bits per packet and
yields low network overhead. Therefore, you must explicitly define the permanent
virtual circuit (PVC) to carry the packet to its destination. You do this with the
LLC2 Frame Relay Mapping Table. The mapping table consists of three fields:
• DLCI
• Remote (or Destination) MAC
• Local MAC (or Source) MAC
Each entry requires that you specify the Remote MAC, Local MAC, or both. A
packet that matches this entry is then forwarded to the specified DLCI.
Bay Networks routers select BNN when you configure the Frame Relay network
without source route encapsulation.
- Configuring DLSw 1
- Services 1
- Bay Networks Software License 3
- Contents 5
- 114063 Rev. A vii 7
- 114063 Rev. A ix 9
- 114063 Rev. A 10
- 114063 Rev. A xi 11
- 114063 Rev. A xiii 13
- 114063 Rev. A xv 15
- About This Guide 17
- Before You Begin 18
- Conventions 18
- Acronyms 19
- 114063 Rev. A xxi 21
- Bay Networks Customer Service 22
- World Wide Web 23
- Customer Service FTP 23
- Support Source CD 24
- CompuServe 24
- InfoFACTS 25
- How to Get Help 25
- Chapter 1 27
- Data Link Switching Overview 27
- DLSw Networking Overview 28
- RFC1795 Support 29
- 1-4 114063 Rev. A 30
- Single-Switch Services 32
- DSW0002A 33
- Dual-Switch Services 34
- SDLC Support 36
- 1-12 114063 Rev. A 38
- Primary SDLC Support 39
- Secondary SDLC Support 40
- 1-16 114063 Rev. A 42
- (b) Dual-Switch DLSw Networks 43
- Frame Relay Support 44
- DLSw Filtering 46
- Protocol Prioritization 47
- Chapter 2 49
- DLSw Implementation Notes 49
- DLSw Session Setup 50
- Combining DLSw and SRB 51
- 2-4 114063 Rev. A 52
- DSW0009A 52
- Virtual Rings 53
- DLSw and SRB On a Circuit 54
- DLSw and Bridging Services 55
- DLSw with Translation Bridge 56
- 2-10 114063 Rev. A 58
- Multiple DLSw Peers on a LAN 59
- Memory Requirements 60
- TCP Considerations 60
- Flow Control 61
- LLC2 Flow Control 62
- TCP Flow Control 62
- DLSw Prioritization 63
- Chapter 3 65
- DLSw Configuration Overview 65
- 114063 Rev. A 3-3 67
- 3-4 114063 Rev. A 68
- DLSW Global Parameters 69
- DLSw SAP Table 70
- SAP Table 71
- 3-8 114063 Rev. A 72
- DLSw Global Parameters 73
- DLSw Slot Table 74
- DLSw Configuration Overview 75
- 3-12 114063 Rev. A 76
- DLSw Peer IP Table 77
- Broadcast Peers 78
- Unconfigured Peers 79
- SDLC Line Parameters 80
- Local Devices 81
- 3-18 114063 Rev. A 82
- Boundary Access Node (BAN) 83
- 3-20 114063 Rev. A 84
- Configuring DLSw Packaging 85
- 3-22 114063 Rev. A 86
- Chapter 4 87
- Starting DLSw the First Time 88
- 4-4 114063 Rev. A 90
- 2. Click on OK 90
- Adding Slot IP Addresses 92
- 114063 Rev. A 4-7 93
- Adding DLSw Peer IP Addresses 94
- 114063 Rev. A 4-9 95
- 4-10 114063 Rev. A 96
- 1. Click on Add 96
- 114063 Rev. A 4-11 97
- 4-12 114063 Rev. A 98
- 99
- 100
- 101
- 101
- 102
- Starting DLSw 103
- 5. Click on Add 103
- Configuring DLSw Services 104
- 4-18 114063 Rev. A 104
- 105
- 4-20 114063 Rev. A 106
- 4-22 114063 Rev. A 108
- 109
- 4-24 114063 Rev. A 110
- 111
- 4-26 114063 Rev. A 112
- 4-28 114063 Rev. A 114
- Mapping Frame Relay Addresses 115
- 4-30 114063 Rev. A 116
- 3. Click on OK 116
- Chapter 5 119
- Editing DLSw Parameters 119
- Accessing DLSw Parameters 120
- (Figure 5-1) and then: 121
- (Figure 5-2) 121
- Click on OK 122
- 5-6 114063 Rev. A 124
- 5-8 114063 Rev. A 126
- 128
- 5-12 114063 Rev. A 130
- Enabling a DLSw Interface 131
- 5-16 114063 Rev. A 134
- (Figure 5-7) 135
- 114063 Rev. A 5-21 139
- 5-22 114063 Rev. A 140
- 3. Click on Done 140
- 5-28 114063 Rev. A 146
- 2. Click on Delete 146
- Adding a DLSw SAP Table Entry 147
- 114063 Rev. A 5-31 149
- Click on Done 150
- 3. Click on Delete 151
- 5-34 114063 Rev. A 152
- 4. Click on Done 152
- (Figure 5-19) 153
- 5-40 114063 Rev. A 158
- 2. Select the entry to edit 161
- Click on Apply 162
- 5-46 114063 Rev. A 164
- 114063 Rev. A 5-47 165
- 5-48 114063 Rev. A 166
- (continued) 169
- 5-52 114063 Rev. A 170
- (continued) 170
- 5-54 114063 Rev. A 172
- 5-56 114063 Rev. A 174
- 5-58 114063 Rev. A 176
- Deleting DLSw from the Node 177
- Chapter 6 179
- Using DLSw Prioritization 179
- 6-2 114063 Rev. A 180
- DLSw Priority Queues 181
- The Enqueuing Process 182
- The Dequeuing Process 182
- 114063 Rev. A 6-5 183
- 6-6 114063 Rev. A 184
- Queue Depth 185
- 6-8 114063 Rev. A 186
- 114063 Rev. A 6-11 189
- 6-12 114063 Rev. A 190
- 191
- 6-16 114063 Rev. A 194
- 114063 Rev. A 6-19 197
- 114063 Rev. A 6-21 199
- 6-24 114063 Rev. A 202
- 2. Click on Template 202
- 114063 Rev. A 6-29 207
- Configuration window 208
- (Figure 6-23) 208
- Appendix A 211
- DLSw Default Settings 211
- A-2 114063 Rev. A 212
- A-4 114063 Rev. A 214
- Appendix B 215
- Predefined DLSw Criteria 216
- DLSw Reference Points 216
- Length (bits) 217
- Specifying MAC Address Ranges 218
- B-6 114063 Rev. A 220
- Table B-6. SAP Codes 220
- Appendix C 221
- DLSw Troubleshooting 221
- *. Enabled by default 222
- Table C-2. DLSw State Table 223
- Sample Log Entries 224
- C-6 114063 Rev. A 226
- Reviewing the Network Log 228
- C-10 114063 Rev. A 230
- C-12 114063 Rev. A 232
- Troubleshooting DLSw 233
- C-16 114063 Rev. A 236
- Unexpected protocol action 238
- TCP open error 29 238
- DLSw Troubleshooting Tables 239
- C-20 114063 Rev. A 240
- C-22 114063 Rev. A 242
- C-24 114063 Rev. A 244
- C-26 114063 Rev. A 246
- Verifying the WAN Cabling 247
- 114063 Rev. A Index-1 249
- 114063 Rev. A Index-3 251
- 114063 Rev. A Index-5 253
- 114063 Rev. A Index-7 255
Manuais e produtos relacionados com Redes Avaya Configuring DLSw Services
Redes Avaya Configuring Branch Office Tunnel between a Contivity and a BayRS Router Manual do Utilizador
(29 páginas)
(29 páginas)
Redes Avaya Call Center Reporting Guia do Utilizador
(37 páginas)
(37 páginas)
Redes Avaya Quick2Config Manual do Utilizador
(110 páginas)
(110 páginas)
Redes Avaya BSG8/12 1.0 Guia de Configuração
(200 páginas)
(200 páginas)
Redes Avaya 1150E Guia do Utilizador
(200 páginas)
(200 páginas)
Redes Avaya BayRS Version 15.0.0.0 Aviso
(72 páginas)
(72 páginas)
Redes Avaya BCM450 Guia de Configuração
(12 páginas)
(12 páginas)
Redes Avaya BayRS Version 12.10 Manual do Utilizador
(194 páginas)
(194 páginas)
Redes Avaya BCM 2.0 Networking Manual do Utilizador
(42 páginas)
(42 páginas)
(32 páginas)
Redes Avaya Configuring SMDS Manual do Utilizador
(50 páginas)
(50 páginas)
Redes Avaya BayRS Version 15.4.2.0 Aviso
(72 páginas)
(72 páginas)
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.068 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais