
Editing DLSw Parameters
114063 Rev. A 5-49
DLSw Local Devices Parameter Descriptions
This section describes the DLSw Local Devices parameters that you can
customize from the DLS Local Device Configuration window.
Parameter: Link Station Address (hex)
Default: None
Range: Any valid hexadecimal link station address from 0x01 to 0xFE
Function: Specifies the address of the link station. This parameter must match the
polling address defined in the SDLC-attached device.
Instructions: Type 0x followed by the link station address.
MIB Object ID: N/A
Parameter: Disable
Default: Enable
Options: Enable
| Disable
Function: Enables or disables the DLSw local device.
Instructions: Set to Disable if you want to temporarily disable the local device, rather
than delete it. Set to Enable if you want to reinitialize the local device.
MIB Object ID: 1.3.6.1.4.1.18.3.5.1.5.12.1.2
Comentários a estes Manuais